Comments on: QuickPwn 2.2 Guide & Tutorial

By: Sebastien

Sebastien — Thu, 21 May 2009 14:30:42 +0000

I am closing the comments for this post. If you have any question about jailbreaking your iPhone, please ask in the forum.

By: Simon

Simon — Thu, 21 May 2009 09:37:18 +0000

Jailbreaked my iPhone using quickpwn and this guide. Worked great! Just one major problem, all my calls are dropping after 1 second!!! Please can anyone advise what the problem is, I was quite enjoying sb settings and icon poof and winterboard so don’t want to go back to standard iPhone.

By: Fajr

Fajr — Thu, 14 May 2009 23:29:09 +0000

Hi Sebastien or anybody,
please help to solve this issue, I try 1st step to restore but itunes asked me to restore the backup from previous sync and doing sync. Once finish, I run the QuickPwn for some step but always stuck on “Wait for your iPhone to connect in Recovery Mode…” .. it stays there forever…..
Any tips to solve this issue???
Thanks in advance…

By: Iphone | R U Asking?

Iphone | R U Asking? — Tue, 12 May 2009 22:06:16 +0000

[...] guys at iphonedownloadblog.com even layout a tutorial to jailbrake and unlock your iphone. Even all of the downloads you need for your [...]

By: Stephen

Stephen — Sun, 10 May 2009 04:48:27 +0000

OMG HELP ME ITS NOT WORKING. I read ev erything Hold Down Home and Power Button but ive been stuck on the appel
for ages

By: zahid

zahid — Wed, 22 Apr 2009 10:32:14 +0000

hi…i hav an iphone 2.0.2….bt i dnt hav a wi-fi at home …so dnt knw how 2 install applets….i hav a pc at home…with itunes…n internet….n aftr dis i dunno how to install applets to my iphone…..plz help me ….mail me…d needfull

By: David

David — Tue, 21 Apr 2009 03:50:06 +0000

I tried to jailbreak my iPhone when it had the 2.2 firmware but experienced a common problem when it would freeze on the apple/pineapple logo. So i restored and was forced to upgrade to 2.2.1. But then i followed this same procedure designed for 2.2.1 and it worked.

iTunes would not recognise my phone so i couldnt restore that way.
What i did was hold the power and home button until it switched off. Then hold the power button to turn it back on. Open iTunes and you should see a message saying that the iPhone is ready to be restored. Then you can try all over again if u want. But remember that when u restored it, it gets upgraded to 2.2.1. So follow the procedure for that firmware or just downgrade to original firmware.

By: Brett

Brett — Sat, 04 Apr 2009 20:33:52 +0000

I stupidly forgot to hold SHIFT when I pressed RESTORE on my Iphone 2G (jailbroken) and not the SIM is locked? Can anyone pls help me?

By: Sorted

Sorted — Wed, 25 Mar 2009 21:58:24 +0000

As a lot of people, i jail broke my iphone and it was stuck on re-boot.
I had half an hour of shitting my pants but, then it just turned on and I was then able to experience my new jail broken iphone.
Be patient, and it should eventually turn on.
It must just need that time to sort itself out.
Good Luck

By: Que Duros.com!!! » Desbloquear IPhone 3G [Inglés]

Que Duros.com!!! » Desbloquear IPhone 3G [Inglés] — Fri, 20 Mar 2009 18:39:25 +0000

[...] your iPhone yet, you have to now in order to unlock. To jailbreak your iPhone, follow the QuickPwn 2.2 guide that I wrote a few weeks [...]